CCNA 3 Final Exam Answers (v+v) – Scaling Networks 1. A network designer is considering whether to implement a swit. View Test Prep – -CCNA 3 Final Exam Answers vv60 Scaling Networks (1).pdf from S at Deakin. CCNA 3 Final Exam Answers CCNA 3 Final Exam V Answers only computer 4 CCNA 2 Final Exam V Answers computer 3 and RTR-A CCNA 1 Chapter 10 V Answers computer 4.

Author: Meztigore JoJozshura
Country: Malta
Language: English (Spanish)
Genre: Literature
Published (Last): 9 November 2011
Pages: 28
PDF File Size: 3.98 Mb
ePub File Size: 2.24 Mb
ISBN: 337-4-66210-340-5
Downloads: 67327
Price: Free* [*Free Regsitration Required]
Uploader: Vukus

What is a possible impact of setting too short an aging time in the MAC address table of a switch?

CCNA 3 Final Exam V4.0 Answers

June 19, at 5: January 11, at 8: This entry can only be removed from the MAC address table by a network administrator. Create a new domain and ansers a second switch as a VTP server to take over in case of a primary VTP server failure. January 12, at 9: July 23, at 1: December 14, at 9: The port will transition into blocking state.

Switches in the existing office and the new office are directly connected by a trunk link. June 17, at 3: Default native vlan is vlan1.


CCNA 3 Final Exam V Answers

The computers in each office are not able to ping each other. Users A and B are reporting intermittent connectivity problems. An administrator is troubleshooting a PC on the network which is suffering from slow and intermittent connectivity.

Download The Cisco Report Today! Which two steps should the administrator perform to achieve this?

September 26, at 6: This allows web-based configuration tools to be used with the switch. Introducing Routing ccha Switching in the Enterprise Version 4. It is plain wrong. While configuring a new switch, a network administrator configures the switch as an HTTP server. The link between the switches is up but not trunked.

CCNA 3 v Exam Answers score %

It segments esam network into multiple broadcast domains. The switch port is configured for auto duplex and the PC is configured for full duplex. The default gateway is not on the same switch that the PC is. Which switch will become the root for VLAN 20?

Allow all VLANs on the trunk link. Which three statements are correct concerning the default configuration of a new switch? Statically configured MAC addresses will automatically be removed from the address table minutes after the last activity on a switch port.

TOP Related Articles  ASTM E647 DOWNLOAD

SW1 is configured with native vlan10 so to change it to would enable the connectivity for hosts on vlan November 30, at 8: Reset the VTP counters. The OFDM modulation technique results in a slower data rate.

The Aanswers is set to full duplex. January 24, at 7: May 5, at 5: April 9, at 2: The Layer 2 switching design that is shown has been implemented in a campus environment that is using Spanning Tree Protocol. It is sending and receiving data frames. Switches S2 and S3 are properly connected using an ethernet cable.

Which three options correctly identify information that could be associated with this output? The port will transition into blocking state and then immediately into forwarding state. Using the command copy tftp: What benefits does this configuration provide?

VTP pruning is disabled.

Configure the new office default gateway to January 23, at 5: What will the router do with this packet?